ABB ACS280 Firmware Manual page 364

Fieldbus control through the embedded fieldbus interface (EFB)
364
Bit Name
5 ACCELERATING
6 DECELERATING
7 AT_SETPOINT
8 LIMIT
9 SUPERVISION
10 REVERSE_REF
11 REVERSE_ACT
12 PANEL_LOCAL
13 FIELDBUS_LOCA
L
14 EXT2_ACT
15 FAULT
16 ALARM
17 Reserved
18 Reserved for
DIRECTION_LOC
K
19 Reserved
20 CTL_MODE
21 Reserved
22 USER_0
23 USER_1
24 USER_2
25 USER_3
Value
1
0
1
0
1
0
1
0 Drive operation is not limited.
1 Actual value (speed, frequency or torque) is above
a limit. Limit is set with parameters 46.31...46.33
0 Actual value (speed, frequency or torque) is within
1
0
1
0
1 Panel/keypad (or PC tool) is in local control mode.
0 Panel/keypad (or PC tool) is not in local control
1 Fieldbus is in local control mode.
0 Fieldbus is not in local control mode.
1 External control location EXT2 is active.
0 External control location EXT1 is active.
1
0
1
0
1 Vector motor control mode is active.
0 Scalar motor control mode is active
Status bits that can be combined with drive logic
for application-specific functionality.
State/Description
Not yet implemented.
Not yet implemented.
Not yet implemented.
Not yet implemented.
Drive is at setpoint.
Drive is not at setpoint.
Drive operation is limited.
limits.
Not yet implemented.
Not yet implemented.
Not yet implemented.
Not yet implemented.
mode.
Drive is faulted.
Drive is not faulted.
Warning/Alarm is active.
No warning/alarm.
Not yet implemented.