ABB ACS280 Firmware Manual page 90

90 Parameters
Terms and abbreviations
Term
Actual signal
Def
FbEq16/32
Other
Other [bit]
Parameter
p.u.
[parameter number]
Fieldbus addresses
Fieldbus control through the embedded fieldbus interface (EFB)
Refer to
Definition
Signal measured or calculated by the drive. Usually can only be
monitored but not adjusted; some counter-type signals can however
be reset.
The default is shown on the same row as the parameter name.
The fieldbus equivalent for 16-bit and 32-bit. They are shown on the
same row as the parameter range, or for each selection.
A dash (-) indicates that the user cannot access the parameter in 16-
bit format.
32-bit fieldbus equivalent: The scaling between the value shown on
the panel and the integer used in communication when a 32-bit value
is selected for transmission to an external system.
The value is taken from another parameter.
Choosing "Other" displays a parameter list in which the user can
specify the source parameter.
The value is taken from a specific bit in another parameter. The user
selects the source from a parameter list.
Either a user-adjustable operating instruction for the drive, or an
Actual signal
.
Per unit
Value of the parameter
.