ABB ACS280 Firmware Manual page 99

No. Name/Value
05
05 Diagnostics
05.01 On-time counter
0...65535 d
05.02 Run-time counter
0...65535 d
05.03 Hours run
0...
429496729.5 h
05.04 Fan on-time counter
0...65535 d
05.10 Control board
temperature
-100... 300 °C or °F
05.11 Inverter temperature
-40.0...160.0%
05.20 Diagnostic word 1
Bit Name
0 Any warning or fault Yes = Drive has generated a warning or tripped on a fault.
1 Any warning
2 Any fault
3 Reserved
4 Overcurrent fault
5 Reserved
6 DC overvoltage
7 DC undervoltage
8 Reserved
9 Device overtemp flt
10...15 Reserved
0b0000...0b1111
Description
Various run-time-type counters and measurements
related to drive maintenance.
All parameters in this group are read-only unless
otherwise noted.
Drive on-time counter. The counter runs when the
drive is powered.
On-time counter (number of days).
Motor run-time counter. The counter runs when the
inverter modulates.
Motor run-time counter.
Corresponding parameter to
in hours, that is, 24 * 05.02
day.
Hours.
Running time of the drive cooling fan. Can be reset
from the control panel by keeping Reset down for
over 3 seconds.
Cooling fan run-time.
Measured temperature of the control board.
Temperature in degrees Celsius for Fahrenheit.
Estimated drive temperature in percent of fault limit.
The fault limit varies according to the type of the
drive.
0.0% = 0 °C (32 °F)
100.0% = Fault limit
Temperature in percent.
Diagnostic word 1. For possible causes and remedies,
Fault tracing
see chapter
Value
Yes = Drive has generated a warning.
Yes = Drive has tripped on a fault.
Yes = Drive has tripped on fault
Yes = Drive has tripped on fault
Yes = Drive has tripped on fault
Yes = Drive has tripped on fault
Diagnostic word 1.
05.02 Run-time counter
value + fractional part of a
.
2310 Overcurrent
3210 DC link overvoltage
3220 DC link undervoltage
4310 Excess temperature
Parameters 99
Default
FbEq 16
-
1 = 1 d
-
1 = 1 d
-
1 = 1 h
-
1 = 1 d
-
1 = unit
-
1 = 1%
0b0000
.
.
.
.
1 = 1