ABB ACS280 Firmware Manual page 290

290 Parameters
No. Name/Value
99.10 Motor nominal power
0.00... 10000.00 kW or
0.00... 13404.83 hp
99.11 Motor nominal cos Φ
0.00...1.00
99.12 Motor nominal torque
0.000...4000000.000
N·m or
0.000...2950248.597
lb·ft
Description
Defines the nominal motor power. The setting must
match the value on the rating plate of the motor. If
multiple motors are connected to the drive, enter the
total power of the motors. The unit is selected by
96.16 Unit selection
parameter
Note: This parameter cannot be changed while the
drive is running.
Nominal power of the motor.
Defines the cosphi of the motor for a more accurate
motor model. This value is not obligatory, but is
useful with an
asynchronous motor, especially when performing a
standstill identification run. With a permanent
magnet or synchronous reluctance motor, this value
is not needed.
Notes:
• Do not enter an estimated value. If you do not know
the
• exact value, leave the parameter at zero.
• This parameter cannot be changed while the drive
is running.
Cosphi of the motor.
Defines the nominal motor shaft torque for a more
accurate motor model. Not obligatory. The unit is
selected by parameter
Note: This parameter cannot be changed while the
drive is running.
Nominal motor torque.
.
96.16 Unit selection
.
Default
FbEq 16
1.10 kW or hp
1 = 0.01 unit
(see par.
46.04
)
0.00
100 = 1
0.000
N·m or lb·ft
1 = 100 unit