ABB ACS280 Firmware Manual page 396

Fieldbus control through the embedded fieldbus interface (EFB)
396
Bit Name
13 RAMP_IN_ZERO
14 REQ_LOCAL_LO
CK
15 Reserved for
TORQ_LIM_PAIR
_2
Status Word for the Transparent 16 Profile
Status word of the Transparent 16 profile can be read from the object 2054h.
Bit Name
0 READY
1 ENABLED
2 Reserved for
ENABLED_TO_R
OTATE
3 RUNNING
4 ZERO_SPEED
5 ACCELERATING
6 DECELERATING
7 AT_SETPOINT
8 LIMIT
9 SUPERVISION
10 REVERSE_REF
11 REVERSE_ACT
Value State/Description
1 Force Ramp Function Generator input to zero.
0 Normal operation.
1 Not yet implemented.
0 Not yet implemented.
Not yet implemented.
Value State/Description
1 Drive is ready to receive the start command.
0 Drive is not ready.
1 External run enable signal is active.
0 External run enable signal is not active.
Not yet implemented.
1 Drive is modulating.
0 Drive is not modulating.
1 Drive is at zero speed.
0 Drive is not at zero speed.
1 Not yet implemented.
0 Not yet implemented.
1 Not yet implemented.
0 Not yet implemented.
1 Drive is at setpoint.
0 Drive is not at setpoint.
1 Drive operation is limited.
0 Drive operation is not limited.
1 Actual value (speed, frequency or torque) is above a
limit. Limit is set with parameters 46.31...46.33
0 Actual value (speed, frequency or torque) is within
limits.
1 Not yet implemented.
0 Not yet implemented.
1 Not yet implemented.
0 Not yet implemented.