ABB ACS280 Firmware Manual page 227

No. Name/Value
Freq in scaled
AI1 percent
AI2 percent
Control panel (ref
saved)
Control panel (ref
copied)
EFB ref1
EFB ref2
Setpoint data storage
Other
40.17 Set 1 setpoint 2 source
40.18 Set 1 setpoint function
In1
In1+In2
In1-In2
In1*In2
In1/In2
MIN(In1,In2)
MAX(In1,In2)
AVE(In1,In2)
sqrt(In1)
sqrt(In1-In2)
Description
11.39 Freq in 1 scaled value
12.101 AI1 percent value
12.102 AI2 percent value
03.01 Panel reference
Panel reference (
saved by the control system for the location where
the control returns is used as the reference.
Reference
Ext1 -> Ext2
03.01 Panel reference
Panel reference (
for the previous control location is used as the
reference when the control location changes if the
references for the two locations are of the same type
(eg frequency/speed/torque/PID); otherwise, the
actual signal is used as the new reference.
Reference
Ext1 -> Ext2
03.09 EFB reference 1
03.10 EFB reference 2
40.92 Setpoint data storage
Source selection (see
Selects the second source of process setpoint. The
second source is used only if the setpoint function
requires two inputs.
For the selections, see parameter
1 source
.
Selects a function between the setpoint sources
selected by parameters
40.17 Set 1 setpoint 2 source
and
Source 1.
Sum of sources 1 and 2.
Source 2 subtracted from source 1.
Source 1 multiplied by source 2.
Source 1 divided by source 2.
Smaller of the two sources.
Greater of the two sources.
Average of the two sources.
Square root of source 1.
Square root of (source 1 - source 2).
, see page
Ext1 reference
Ext2 reference
Active reference
Inactive reference
t
, see page
Ext1 reference
Ext2 reference
Active reference
Inactive reference
t
Terms and abbreviations
40.16 Set 1 setpoint
40.16 Set 1 setpoint 1 source
.
Parameters 227
Default
FbEq 16
10
11
12
96
) 13
96
) 14
19
20
24
). -
not used
In1
0
1
2
3
4
5
6
7
8
9