ABB ACS280 Firmware Manual page 130

130 Parameters
No. Name/Value
In1P Start; In2 Stop
In1P Start; In2 Stop; In3
Dir
In1P Start fwd; In2P
Start rev; In3 Stop
Control panel
Description
The sources of the start and stop commands are
selected by parameters
20.09 Ext1 in2 source
. The state transitions of the
source bits are interpreted as follows:
State of source 1 State of source 2
(20.08)
0 - > 1
Any
Notes:
20.07 Ext2 start trigger type
• Parameter
effect with this setting.
• When source 2 is 0, the Start and Stop keys on the
control panel are disabled.
The sources of the start and stop commands are
selected by parameters
20.09 Ext1 in2 source
. The source selected by
Ext2 in3 source
determines the direction. The state
transitions of the source bits are interpreted as
follows:
State of State of
source 1 source 2
(20.08) (20.09)
0 - > 1
1
0 - > 1
1
Any 0
Notes:
20.07 Ext2 start trigger type
• Parameter
effect with this setting.
• When source 2 is 0, the Start and Stop keys on the
control panel are disabled.
The sources of the start and stop commands are
selected by parameters
Ext1 in2 source 20.10 Ext2 in3 source
and
20.10 Ext2 in3 source
selected by
direction. The state transitions of the source bits are
interpreted as follows:
State of State of
source 1 source 2
(20.08) (20.09)
0 - > 1
Any
0 - > 1
Any
Any Any
20.07 Ext2 start trigger type
Note: Parameter
effect with this setting.
Start; stop and direction commands through control
panel; when EXT1 is active. Applies also for PC-Tool
when it is connected via panel port.
20.08 Ext2 in1 source
and
Command
(20.09)
1 Start
0 Stop
has no
20.08 Ext2 in1 source
and
20.10
State of
source 3 Command
(20.10)
0 Start forward
1 Start reverse
Any Stop
has no
20.08 Ext2 in1 source 20.09
,
. The source
determines the
State of
source 3 Command
(20.10)
1 Start forward
1 Start reverse
0 Stop
has no
Default
FbEq 16
4
5
6
11