ABB ACS280 Firmware Manual page 278

278 Parameters
No. Name/Value
96.69 Actual checksum B
0x0000...0xffff
96.70 Disable adaptive
program
No
Yes
96.71 Approved checksum A
0x0000...0xffff
96.72 Approved checksum B
0x0000...0xffff
96.100 Change user pass code
10000000...
99999999
96.101 Confirm user pass code
10000000...
99999999
Description
Displays the actual parameter configuration
checksum B. The checksum B is generated and
updated whenever an action is selected in
Checksum action 96.55 Checksum control word
and
bit 9 = 1 (Approved checksum B)
The set of parameters for checksum B does not
include:
• fieldbus settings
• motor data settings, and
• energy data settings parameters.
The parameters included in the checksum B
calculation are user editable parameters in parameter
groups 10, 15, 19, 20, 21, 22, 23, 24, 25, 28, 30, 31, 32, 35,
36, 37, 40, 41, 46, 71, 95, 96, and 97.
Parameter checksum calculation
See also section
84
(page ).
Actual checksum B.
Selects if the adaptive program is enabled or disabled
Adaptive program is enabled. Adaptive program is set
to running mode automatically when drive is powered
on. Commanding adaptive program to running mode
is possible from PC tool.
Adaptive program is disabled. Setting adaptive
program to running mode is not possible. If adaptive
program was running when disabled, then adaptive
program is stopped and set to init state.
Approved (reference) checksum A.
Approved checksum A.
Approved (reference) checksum B.
Approved checksum B.
(Visible when user lock is open)
To change the current user pass code, enter a new
code into this parameter as well as
user pass code
. A warning
new pass code is confirmed. To cancel changing the
pass code, close the user lock without confirming. To
close the lock, enter an invalid pass code in parameter
96.02 Pass code
, activate parameter
board boot
, or cycle the power.
User lock
See also section
New user pass code.
(Visible when user lock is open)
Confirms the new user pass code entered in
Change user pass code
Confirmation of new user pass code.
96.54
96.101 Confirm
A6B1
will be active until the
96.08 Control
86
(page ).
96.100
.
Default
FbEq 16
0x0000
,
1 = 1
0
1
0x0000
-
0x0000
-
10000000
-
-