ABB ACS280 Firmware Manual page 232

232 Parameters
No. Name/Value
Used
DI1
DI2
DI3
DI4
Supervision 1
Supervision 2
Supervision 3
Other [bit]
40.39 Set 1 deadband range
40.39 Set 1
deadband range
Feedback
PID controller
0......200000.0
40.40 Set 1 deadband delay
0.0 ... 3600.0 s
40.43 Set 1 sleep level
0.0...200000.0
Description
Process PID controller output frozen.
Digital input DI1 (
Digital input DI2 (
Digital input DI3 (
Digital input DI4 (
32.01 Supervision status
Bit 0 of
32.01 Supervision status
Bit 1 of
32.01 Supervision status
Bit 2 of
Source selection (see
Defines a deadband around the setpoint. Whenever
process feedback enters the deadband, a delay timer
starts. If the feedback remains within the deadband
longer than the delay (
the PID controller output is frozen. Normal operation
resumes after the feedback value leaves the
deadband.
Setpoint
output
Deadband range.
Delay for the deadband. See parameter
deadband range
Delay for deadband area.
Defines the start limit for the sleep function. If the
value is 0.0, set 1 sleep mode is disabled.
The sleep function compares the motor speed to the
value of this parameter. If the motor speed remains
below this value longer than the sleep delay defined
40.44 Set 1 sleep delay
by
mode and stops the motor.
Sleep start level.
10.02 DI delayed status
10.02 DI delayed status
10.02 DI delayed status
10.02 DI delayed status
.
Terms and abbreviations
40.40 Set 1 deadband delay
40.40 Set 1 deadband delay
.
, the drive enters the sleep
Default
FbEq 16
1
, bit 0). 2
, bit 1). 3
, bit 2). 4
, bit 3). 5
21
22
23
). -
0.00
),
PID controller
output frozen
Time
1=1
40.39 Set 1
0.0 s
1 = 1 s
0.0
1 = 1