ABB ACS280 Firmware Manual page 247

No. Name/Value
45.19 Comparison power
0.00...100000.00 kW
45.21 Energy calculations
reset
Done
Reset
45.24 Hourly peak power
value
-3000.00 ... 3000.00
kW
45.25 Hourly peak power
time
45.26 Hourly total energy
(resettable)
-3000.00 ... 3000.00
kWh
45.27 Daily peak power value
(resettable)
-3000.00 ... 3000.00
kW
45.28 Daily peak power time
45.29 Daily total energy
(resettable)
-30000.00 ... 30000.00
kWh
45.30 Last day total energy
Description
Actual power that the motor absorbs when
connected direct-on-line and operating the
application. The value is used for reference when
energy savings are calculated.
Note: The accuracy of the energy savings calculation
is directly dependent on the accuracy of this value. If
nothing is entered here, then the nominal motor
power is used by the calculation, but that may inflate
the energy savings reported as many motors do not
absorb nameplate power.
Motor power.
Resets the savings counter parameters
Reset not requested (normal operation), or reset
complete.
Reset the savings counter parameters. The value
reverts automatically to
Value of the peak power during the last hour, that is,
the most recent 60 minutes after the drive has been
powered up.
The parameter is updated once every 10 minutes
unless the hourly peak is found in the most recent 10
minutes. In that case, the values is shown
immediately.
Peak power value.
Time of the peak power value during the last hour.
Time.
Total energy consumption during the last hour, that
is, the most recent 60 minutes.
You can reset the value by setting it to zero.
Total energy.
Value of the peak power since midnight of the
present day.
You can reset the value by setting it to zero.
Peak power value.
Time of the peak power since midnight of the present
day.
Time.
Total energy consumption since midnight of the
present day.
You can reset the value by setting it to zero.
Total energy.
Total energy consumption during the previous day,
that is, between midnight of the previous day and
midnight of the present day
45.01
...
Done
.
Parameters 247
Default
FbEq 16
0.00 kW
1 = 1 kW
45.10 Done
.
0
1
0.00 kW
10 = 1 kW
00:00:00
N/A
0.00 kWh
10 = 1 kWh
0.00 kW
10 = 1 kW
00:00:00
N/A
0.00 kWh
1 = 1 kWh
0.00 kWh