Programmable Relay Outputs; Fieldbus Control; Motor Control; Motor Types - ABB ACS280 Firmware Manual



Programmable relay outputs

There is one relay output. The signal indicated by the output can be selected by
a parameter.
Settings and diagnostics
10.22
Parameter ...
Events: -

Fieldbus control


The drive can be connected to an automation systems through its fieldbus
interface. See chapter
interface (EFB)
.
Settings and diagnostics
Parameter group
Events: -

Motor control



Motor types

The drive supports the following motor types:
• Asynchronous AC induction motors
• Permanent magnet (PM) motors
• Permanent Magnet Assisted Synchronous Reluctance Machine
Settings and diagnostics
99.03 Motor type
Parameter
Events: -


Motor identification

In scalar motor control mode (
identification. The performance of vector control is based on an accurate motor
model determined during the motor start-up.
A motor Identification magnetization is automatically performed the first time
the start command is given. During this first start-up, the motor is magnetized
at zero speed for several seconds to allow the motor model to be created. This
identification method is suitable for most applications in vector control mode.
In demanding applications a separate Identification run (ID run) can be
performed.
10.24 RO1 source
.
Fieldbus control through the embedded fieldbus
58 Embedded fieldbus
.
99.04
.
), the drive performs no motor
Program features 35