ABB ACS280 Firmware Manual page 257

No. Name/Value
58.10 All packets
0...4294967295
58.11 UART errors
0...4294967295
58.12 CRC errors
0...4294967295
58.14 Communication loss
action
No action
Fault
Last speed
Speed ref safe
Description
Displays a count of valid packets addressed to any
device on the bus. During normal operation, this
number increases constantly.
Can be reset from the control panel by keeping Reset
down for over 3 seconds.
58.01
Note: If parameter
parameter is hidden.
Number of all received packets.
Displays a count of character errors received by the
drive. An increasing count indicates a configuration
problem on the bus.
Can be reset from the control panel by keeping Reset
down for over 3 seconds.
58.01
Note: If parameter
parameter is hidden.
Number of UART errors.
Displays a count of packets with a CRC error received
by the drive. An increasing count indicates
interference on the bus.
Can be reset from the control panel by keeping Reset
down for over 3 seconds.
58.01
Note: If parameter
parameter, is hidden.
Number of CRC errors.
Selects how the drive reacts to an EFB
communication break. The drive does not trip if only
reference is coming from EFB and the communication
is lost.
Changes to this parameter take effect after the
control unit is rebooted or the new settings validated
58.06 Communication control
by parameter
settings
).
58.15 Communication loss mode
See also parameters
58.16 Communication loss time
and
No action taken (monitoring disabled).
6681 EFB comm loss
Drive trips on
control in the currently active control location is
expected from the EFB.
A7CE EFB comm loss
Drive generates an
freezes the speed to the level the drive was operating
at. The speed is determined on the basis of actual
speed using 850 ms low-pass filtering. This occurs
only if control is expected from the EFB.
WARNING! Make sure that it is safe to continue
operation in case of a communication break.
A7CE EFB comm loss
Drive generates an
sets the speed to the speed defined by parameter
22.41 Speed ref safe
(or
frequency reference is being used). This occurs only if
control is expected from the EFB.
WARNING! Make sure that it is safe to continue
operation in case of a communication break.
= [3] CANopen, this
= [3] CANopen, this
= [3] CANopen, this
Refresh
(
.
. This occurs only if
warning and
warning and
28.41 Frequency ref safe
Parameters 257
Default
FbEq 16
-
1 = 1
-
1 = 1
-
1 = 1
Fault
0
1
2
3
when