Motor Potentiometer - ABB ACS280 Firmware Manual

The set of parameters for checksum B does not include:
• fieldbus settings
• motor data settings, and
• energy data settings parameters.
The parameters included in the checksum B calculation are user editable
parameters in parameter groups 10, 15, 19, 20, 21, 22, 23, 24, 25, 28, 30, 31, 32, 35,
36, 37, 40, 46, 95, 96, and 97.
Settings and diagnostics
96.54
Parameters
A686 Checksum mismatch
Events
339 6200 Checksum mismatch
) and
Events: -


Motor potentiometer

The motor potentiometer is a counter whose value can be adjusted up and
down using two digital signals selected by parameters.
When enabled, the motor potentiometer assumes a set value. Depending on the
mode selected, the motor potentiometer value is either retained or reset over a
power cycle.
The change rate is defined as the time it would take for the value to change
from the minimum to the maximum, or vice versa. If the up and down signals are
simultaneously on, the motor potentiometer value does not change.
The output of the function is shown, and it can be directly set as the reference
source in the main selector parameters, or used as an input by other source
selector parameters.
96.55 96.68 96.69
... , ...
(page
96.71 96.72
and ...
333 B686 Checksum mismatch
),
344
(page ).
Program features 85
.
(page