ABB ACS280 Firmware Manual page 79
Coldplate drives
Hide thumbs
Also See for ACS280:
- Quick installation and start-up manual (2 pages) ,
- Hardware manual (144 pages) ,
- User manual (100 pages)
Table of Contents
Advertisement
Program features 79
12.03
12.05
AI supervision (parameters
...
)
The parameters select how the drive reacts when an analog input signal moves
out of the minimum and/or maximum limits specified for the input.
31.32
31.33
Ramp stop supervision (parameters
and
)
The control program has a supervision function for both the normal and
emergency stop ramps. The user can either define a maximum time for
stopping, or a maximum deviation from the expected deceleration rate. If the
drive fails to stop in the expected manner, a fault is generated and the drive
coasts to a stop.
31.30
Custom motor current fault limit (parameter
)
The control program sets a motor current limit based on drive hardware. In
most cases, the default value is appropriate. However, a lower limit can be
manually set by the user, for example, to protect a permanent magnet motor
from demagnetization.
Advertisement
Table of Contents
