ABB ACS280 Firmware Manual page 243

No. Name/Value
Supervision 4
Supervision 5
Supervision 6
Other [bit]
44.12 Brake close request
Not used
Used
DI1
DI2
DI3
DI4
DIO1
DIO2
Not used
Timed function 1
Timed function 2
Timed function 3
Supervision 1
Supervision 2
Supervision 3
Supervision 4
Supervision 5
Supervision 6
Other [bit]
Description
Bit 3 of 32.01 Supervision status.
Bit 4 of 32.01 Supervision status.
Bit 5 of 32.01 Supervision status.
Terms and abbreviations
Source selection (see
Selects the source of an external brake close request
signal. When on, the signal overrides the internal logic
and closes the brake.
0 = Normal operation/No external close signal
connected
1 = Close brake
Notes:
• In an open-loop (encoderless) application, if the
brake is kept closed by a brake close request
against a modulating drive for longer than 5
seconds, the brake is forced to close and the drive
trips on a fault, 71A5 Mechanical brake opening not
allowed.
• This parameter cannot be changed while the drive
is running.
0.
1.
Digital input DI1 (10.02 DI delayed status, bit 0).
Digital input DI2 (10.02 DI delayed status, bit 1).
Digital input DI3 (10.02 DI delayed status, bit 2).
Digital input DI4 (10.02 DI delayed status, bit 3).
Digital input/output DIO1 (11.02 DIO delayed status,
bit 0).
Digital input/output DIO2 (11.02 DIO delayed status,
bit 1)
0.
Bit 0 of 34.01 Timed functions status.
Bit 1 of 34.01 Timed functions status.
Bit 2 of 34.01 Timed functions status.
Bit 0 of 32.01 Supervision status.
Bit 1 of 32.01 Supervision status.
Bit 2 of 32.01 Supervision status.
Bit 3 of 32.01 Supervision status.
Bit 4 of 32.01 Supervision status.
Bit 5 of 32.01 Supervision status.
Terms and abbreviations
Source selection (see
Parameters 243
Default
FbEq 16
27
28
29
). -
Not used
0
1
2
3
4
5
10
11
0
18
19
20
24
25
26
27
28
29
). -