ABB ACS280 Firmware Manual page 353

Fieldbus control through the embedded fieldbus interface (EFB)
Parameter
58.15 Communication
loss mode
58.16 Communication
loss time
58.17 Transmit delay
58.25 Control profile
58.26 EFB ref1 type
58.27 EFB ref2 type
58.28 EFB act1 type
58.29 EFB act2 type
58.31 EFB act1
transparent
58.32
source
EFB act2
transparent
source
58.33 Addressing
mode
58.34 Word order
Setting for
fieldbus control
Cw / Ref1 / Ref2
(default)
3.0 s (default)
0 ms (default)
ABB Drives
(default)
Speed or
(default
frequency
for 58.26),
Transparent,
General, Torque
(default for
58.27), Speed,
Frequency
Speed or
(default
frequency
for 58.28),
Transparent
(default for
58.29), General,
Torque, Speed,
Frequency
Other
(default)
Mode 0
(default)
LO-HI
Function/Information
Enables/disables communication loss
monitoring and defines the means for
resetting the counter of the
communication loss delay.
Defines the timeout limit for the
communication monitoring.
Defines a response delay for the drive.
Selects the control profile used by the
drive. See section
Basics of the embedded
fieldbus interface
Defines the types of fieldbus references 1
and 2. The scaling for each reference type
is defined by parameters 46.01...46.03.
With the
Speed or frequency
type is selected automatically according to
the currently active drive control mode.
Defines the types of actual values 1 and 2.
The scaling for each actual value type is
defined by parameters 46.01...46.03. With
the
Speed or frequency
selected automatically according to the
currently active drive control mode.
Defines the source of actual values 1 and 2
when the 58.26 EFB ref1 type (58.27 EFB
type) is set to Transparent.
ref2
Defines the mapping between parameters
and holding registers in the
400001...465536 (100...65535) Modbus
register range.
Defines the order of the data words in the
Modbus message frame.
353
(page 356).
setting, the
setting, the type is