ABB ACS280 Firmware Manual page 254

254 Parameters
No. Name/Value
Speed ref safe
49.06 Refresh settings
Done
Configure
40
58 Embedded fieldbus
58.01 Protocol enable
None
Modbus RTU
CANopen
58.02 Protocol ID
58.03 Node address
0...255
Node ID
0...255
Description
A7EE Panel loss
Drive generates an
the speed to the speed defined by parameter
Speed ref safe 28.41 Frequency ref safe
(or
frequency reference is being used).
WARNING! Make sure that it is safe to continue
operation in case of a communication break.
Applies the settings of parameters
Note: Refreshing may cause a communication break,
so reconnecting the drive may be required.
Refresh done or not requested.
49.01
Refresh parameters
Done
automatically to .
Configuration of the embedded fieldbus (EFB)
interface.
Fieldbus control through the embedded
See chapter
fieldbus interface (EFB)
Enables/disables the embedded fieldbus interface
and selects the protocol to use.
None (communication disabled).
Embedded fieldbus interface is enabled and uses the
Modbus RTU protocol.
Embedded fieldbus interface is enabled and uses the
CANopen protocol.
Displays the protocol ID and revision.
This parameter is read-only.
Protocol ID and revision.
Defines the node address of the drive on the fieldbus
link.
Values 1...247 are allowable. Two devices with the
same address are not allowed on-line.
Changes to this parameter take effect after the
control unit is rebooted or the new settings validated
58.06 Communication control
by parameter
settings
).
58.01
Note: If parameter
58.03
this parameter, is Node ID (see below).
Node address (values 1...247 are allowed).
Defines the node address for the drive on the
CANopen bus.
Values 1...127 are allowable. Two devices with the
same address are not allowed on-line.
Changes to this parameter take effect after the
control unit is rebooted or the new settings are
validated by parameter
Refresh settings
( ).
58.01
Note: If = [1] Modbus RTU, the name of this
58.03
parameter is Node address (see above).
Node address (values 1...127 are allowed).
warning and sets
when
49.01 49.05
...
49.05
... . The value reverts
.
Refresh
(
= [3] CANopen, the name of
58.06 Communication control
Default
FbEq 16
3
22.41
Done
.
0
1
None
0
1
3
-
1 = 1
1
1=1
3
1=1