ABB ACS280 Firmware Manual page 112

112 Parameters
No. Name/Value
10.99 RO/DIO control word
Bit Name
0 RO1
8 DO1
0000h...FFFFh
10.101 RO1 toggle counter
0...4294967000
11
11 IO mode configuration
11.02 DO delayed status
DO1
0000b...0001b
11.03 DO force selection
Bit Value
0 1 = Force DO1 to value of bit 0 of parameter
1...15 Reserved
0000h...FFFFh
Description
Storage parameter for controlling the relay outputs
eg. through the embedded fieldbus interface. To
control the relay outputs (RO) of the drive, send a
control word with the bit assignments shown below
as Modbus I/O data. Set the target selection
parameter of that particular data (
RO/DIO control word
. In the source selection
parameter of the desired output, select the
appropriate bit of this word.
Description
Source bits for relay outputs (see parameter
RO control word.
Displays the number of times relay output RO1 has
changed states.
State change count.
Configuration of the digital inputs/outputs (DIO) for
use as digital inputs,
Displays the delayed status of digital outputs DO1.
This word is updated only after
activation/deactivation delays (if any are specified).
Example: 0001 = DO1 is on.
This parameter is read-only.
Delayed status of digital output 1.
Status of digital outputs.
Selects the digit output that will be controlled by
11.04
parameter . The signals connected to the digit
output can be overridden for eg. testing purposes.
11.04 DO force data
bit0 in parameter
digit output, and its value is applied whenever the
corresponding bit0 in this parameter is 1.
Note: Boot and power cycle reset the force selections
11.03
(parameters and
Forced selections of digital inputs/outputs.
58.101 58.114
...
is provided for
11.04
).
11.04 DO force data
Default
FbEq 16
0000h
) to
10.24
).
1 = 1
-
1 = 1
-
1 = 1
1 = 1
0000h
.
1=1