ABB ACS280 Firmware Manual page 274

274 Parameters
No. Name/Value
96.07 Parameter save
manually
Done
Save
96.08 Control board boot
0
1
96.10 User set status
n/a
Loading
Saving
Faulted
User1 IO active
User2 IO active
User3 IO active
User4 IO active
User1 backup
User2 backup
User3 backup
User4 backup
Description
Saves the valid parameter values to the permanent
memory on the drive control board to ensure that
operation can continue after cycling the power. Use
this parameter to store values sent from the fieldbus.
Note: A new parameter value is saved automatically
when changed from the PC tool or control panel but
not when altered through a fieldbus adapter
connection.
Save completed.
Save in progress.
Changing the value of this parameter to 1 reboots the
control unit (without requiring a power off/on cycle
of the complete drive module).
The value reverts to 0 automatically.
No action
Reboot the control unit.
Shows the status of the user parameter sets.
This parameter is read-only.
User parameter sets
See also section
No user parameter sets have been saved.
A user set is being loaded.
A user set is being saved.
Invalid or empty parameter set.
User set 1 has been selected by parameters
set I/O mode in1 96.13 User set I/O mode in2
and
User set 2 has been selected by parameters
User set I/O mode in1
in2
.
User set 3 has been selected by parameters
User set I/O mode in1
in2
.
User set 4 has been selected by parameters
User set I/O mode in1
in2
.
User set 1 has been saved or loaded.
User set 2 has been saved or loaded.
User set 3 has been saved or loaded.
User set 4 has been saved or loaded.
83
(page
96.12 User
96.12
96.13 User set I/O mode
and
96.12
96.13 User set I/O mode
and
96.12
96.13 User set I/O mode
and
Default
FbEq 16
Done
0
1
0
1 = 1
-
).
0
1
2
3
4
.
5
6
7
20
21
22
23