ABB ACS280 Firmware Manual page 350

350 Fault tracing
Code
Fault / Aux. code
(hex)
000E...0010 Internal error.
FF8E EFB force trip
Cause
000D (Permanent magnet motors
only)
Second acceleration did not
finish within reasonable
time.
0011 (Synchronous reluctance
motors only)
Pulse test error.
0013 (Asynchronous motors only)
Motor data error.
A fault trip command has
been received through the
embedded fieldbus
interface.
What to do
Contact your local ABB representative.
Contact your local ABB representative.
Contact your local ABB representative.
Check that the motor nominal value
settings in the drive are the same as in
the motor nameplate.
Contact your local ABB representative.
Check the fault information provided
by the PLC.