ABB ACS280 Firmware Manual page 276

276 Parameters
No. Name/Value
Supervision 4
Supervision 5
Supervision 6
Other [bit]
96.13 User set I/O mode in2
96.16 Unit selection
Bit Name
0 Power unit
(mechanical)
1 Reserved
2 Temperature
unit
3 Reserved
4 Torque unit
5...15 Reserved
0b0000...0b1111
96.51 Clear fault and event
logger
Done
Reset
96.54 Checksum action
No action
Pure event
Warning
Warning and prevent
start
Fault
Description
32.01 Supervision status
Bit 3 of
32.01 Supervision status
Bit 4 of
32.01 Supervision status
Bit 5 of
Terms and abbreviations
Source selection (see
96.12 User set I/O mode in1
See parameter
Selects the unit of parameters indicating power,
temperature and torque.
Information
0 = kW
1 = hp
0 = °C
1 = °F
0 = Nm (N·m)
1 = lbft (lb·ft)
Unit selection word.
Clears all events from the drive's fault and event logs.
0 = No action.
1 = Resets (clears) fault and event logger.
Selects how the drive reacts
96.55 Checksum control word
• when
(Approved checksum A): if the parameter
96.68 Actual checksum A
checksum
96.71 Approved checksum A
match
96.55 Checksum control word
• when
(Approved checksum B): if the parameter
96.69 Actual checksum B
checksum
96.72 Approved checksum B
match
No action taken. (The checksum feature is not in use.) 0
The drive generates an event log entry (
Checksum mismatch
).
The drive generates a warning (
mismatch
).
The drive generates a warning (
mismatch
).
Starting the drive is prevented.
6200 Checksum mismatch
The drive trips on
.
.
).
.
, bit 8 = 1
does not
, and/or
, bit 9 = 1
does not
.
B686
A686 Checksum
A686 Checksum
.
Default
FbEq 16
27
28
29
-
not used
0b0000
1 = 1
Done
0
1
No action
1
2
3
4