ABB ACS280 Firmware Manual page 120

120 Parameters
No. Name/Value
0.00... 100.00
12.110 AI dead band
0%...100%
13
13 Standard AO
13.02 AO force selection
Bit Value
0 1 = Force AO1 to value of parameter
1...15 Reserved.
0000h...FFFFh
13.11 AO1 actual value
0.000...11.000 V
13.12 AO1 source
Zero
Motor speed used
Output frequency
Motor current
Motor current % of
motor nom
Motor torque
DC voltage
Output power
Speed ref ramp in
Speed ref ramp out
Speed ref used
Freq ref used
Process PID out
Description
AI2 value
AI dead band value in percentage where 100% = 10 V
in voltage mode and 100% = 20 mA in current mode.
Applicable to both AI1 and AI2.
Note: 10% of AI dead band value is internally added in
firmware as AI dead band hysteresis positive and
negative.
AI dead band
(See section
dead band value
Configuration of standard analog outputs.
Selects the analog outputs that will be forced to
values defined by parameters.
The true source signals of the analog outputs can be
overridden for eg. testing purposes. A forced value
parameter is provided for each analog output, and its
value is applied whenever the corresponding bit in
this parameter is 1.
Note: Boot and power cycle reset the force selections
13.02
(parameters and
13.13 AO1 forced value
Forced values selector for analog output AO1.
Displays the value of AO1 in V.
This parameter is read-only.
Value of AO1.
Selects a signal to be connected to analog output
AO1.
None.
01.01 Motor speed used
01.06 Output frequency
01.07 Motor current
01.08 Motor current % of motor nom
01.10 Motor torque
01.11 DC voltage
01.14 Output power
23.01 Speed ref ramp input
23.02 Speed ref ramp output
24.01 Used speed reference
28.02 Frequency ref ramp output
40.01 Process PID output actual
87
on page .)
13.11
).
.
.
Default
FbEq 16
100 = 1%
0.40%
1 = 1
0000h
1 = 1
-
1 = 1 V
Output
frequency
0
1
3
4
5
6
7
8
10
11
12
14
16