ABB ACS280 Firmware Manual page 105

No. Name/Value
06.18 Start inhibit status
word
Bit Name
0 Not ready run
1 Ctrl location changed * 1 = Control location has changed
2 SSW inhibit
3 Fault reset
4 Lost start enable
5 Lost run enable
6 Reserved
7 STO
8 Current calibration
ended
9 ID run ended
10 Reserved
11 Em Off1
12 Em Off2
13 Em Off3
14 Auto reset inhibit
15 Jogging active
0000h...FFFFh
06.19 Speed control status
word
Bit Name
0 Zero speed
1 Forward
2 Reverse
3 Out of window
Internal speed
4
feedback
Any constant speed
7
request
10...15 Reserved
0000h...FFFFh
Description
Start inhibit status word. This word specifies the
source of the inhibiting signal that is preventing the
drive from starting.
The conditions marked with an asterisk (*) only
require that the start command is cycled to reset the
inhibition. In all other instances, the inhibiting
condition must be removed first.
06.16 Drive status word 1
See also parameter
This parameter is read-only.
Description
1 = DC voltage is missing or drive has not been parametrized
correctly. Check the parameters in groups 95 and 99.
1 = Control program is keeping itself in inhibited state
* 1 = A fault has been reset
1 = Start enable signal missing
1 = Run enable signal missing
1 = Safe torque off function active
* 1 = Current calibration routine has finished
* 1 = Motor identification run has finished
-
1 = Emergency stop signal (mode off1)
1 = Emergency stop signal (mode off2)
1 = Emergency stop signal (mode off3)
1 = The autoreset function is inhibiting operation
1 = The jogging enable signal is inhibiting operation
Start inhibit status word.
Speed control status word.
This parameter is read-only.
Description
1 = Drive has been running below zero speed limit (par.
21.06
)
for a time defined by parameter
1 = Drive is running in forward direction above zero speed
21.06
limit (par.
1 = Drive is running in reverse direction above zero speed
21.06
limit (par.
Speed out of speed window
Estimate used for motor control
1 = A constant speed or frequency has been selected; see
06.20
par. below.
Speed control status word.
21.07 Zero speed delay
)
)
Parameters 105
Default
FbEq 16
-
, bit 1.
1 = 1
--
1 = 1