ABB ACS280 Firmware Manual page 372

Fieldbus control through the embedded fieldbus interface (EFB)
372
Code Function name
2Bh / 0Eh Encapsulated Interface
 Exception codes
The table below shows the Modbus exception codes supported by the
embedded fieldbus interface.
Code
01h ILLEGAL FUNCTION
02h ILLEGAL ADDRESS
03h ILLEGAL VALUE
04h DEVICE FAILURE
Coils (0xxxx reference set)

Coils are 1-bit read/write values. Control Word bits are exposed with this data
type. The table below summarizes the Modbus coils (0xxxx reference set). Note
that the references are 1-based index which match the address transmitted on
the wire.
Reference
000001
000002
Transport
• 0Eh Read Device Identification: Allows reading the
• 00h: Request to get the basic device identification
• 04h: Request to get one specific identification
• 00h: Vendor Name ("ABB")
• 01h: Product Code (for example, "AMGKX")
• 02h: Major Minor Revision (combination of contents
• 03h: Vendor URL ("www.abb.com")
• 04h: Product name: ("ACS280").
Name
The requested quantity of registers is larger than
that a value written to the device is outside of the
was attempting to perform the requested action.
ABB Drives profile
OFF1_CONTROL
OFF2_CONTROL
Description
Supported subcodes:
identification and other information.
Supported ID codes (access type):
(stream access)
object (individual access)
Supported Object IDs:
of parameters 07.05 Firmware version
Protocol ID).
Description
The function code received in the query is not an
allowable action for the server.
The data address received in the query is not an
allowable address for the server.
the device can handle. This error does not mean
valid range.
An unrecoverable error occurred while the server
See section
Error code registers (holding registers
400090...400100)
and 58.02
on page 375.
DCU Profile
STOP
START