ABB ACS280 Firmware Manual page 263

No. Name/Value
58.70 EFB debug mode
Disable
Enable
58.71 EFB reference 1
-100000...100000
58.72 EFB reference 2
-100000...100000
58.73 EFB actual value 1
-100000...100000
58.74 EFB actual value 2
-100000...100000
58.76 RPDO1 COB-ID
Description
This parameter enables debug mode. RAW-data is
echoed to drive parameters
58.71 EFB reference 1 58.72 EFB reference 2
,
status word 58.73 EFB actual value 1
,
actual value 2
Changes to this parameter take effect after the
control unit is rebooted or the new settings validated
58.06 Communication control
by parameter
settings
).
58.01
Note: If parameter
parameter is hidden.
Debug mode disabled.
EFB reference 1 58.72 EFB reference 2
,
status word 58.73 EFB actual value 1
,
actual value 2
are not updated.
Debug mode enabled.
EFB reference 1 58.72 EFB reference 2
,
status word 58.73 EFB actual value 1
,
actual value 2
are updated.
Displays the raw (unmodified) reference value 1for
debugging purposes.
This parameter is read-only.
58.01
Note: If parameter
parameter is hidden.
Reference value 1
Displays the raw (unmodified) reference value 2 for
debugging purposes.
This parameter is read-only.
58.01
Note: If parameter
parameter is hidden.
Reference value 2
Displays the raw (unmodified) actual value 1 for
debugging purposes.
This parameter is read-only.
58.01
Note: If parameter
parameter is hidden.
Actual value 1
Displays the raw (unmodified) actual value 2 for
debugging purposes.
This parameter is read-only.
58.01
Note: If parameter
parameter is hidden.
Actual value 2
Set the COB-ID of the PDO.
Changing this parameter has an effect only if
Configuration location
the control unit is rebooted or the new settings
validated by parameter
Refresh settings
( ).
58.01
Note: If parameter
parameter is hidden.
58.18 EFB control word
58.19 EFB
,
58.74 EFB
and
(
= [1] Modbus RTU, this
58.18 EFB control word
58.19 EFB
,
58.74 EFB
and
58.18 EFB control word
58.19 EFB
,
58.74 EFB
and
= [1] Modbus RTU, this
= [1] Modbus RTU, this
= [1] Modbus RTU, this
= [1] Modbus RTU, this
Drive parameters
is and after
58.06 Communication control
= [1] Modbus RTU, this
Parameters 263
Default
FbEq 16
1
,
Refresh
58.71
, 0
58.71
, 1
0
1=1
0
1=1
0
1=1
0
1=1
0x0001
58.23