LEGRAND Server Technology PRO4X User Manual page 488

▶
Determine the authentication type and enable/disable the option of switching to local
authentication:
config:# authentication type <option1> useLocalIfRemoteUnavailable
<option2>
Note: You cannot enable or disable the option of switching to local authentication without determining
the authentication type in the CLI. Therefore, always type "authentication type <option1>" when setting
up "useLocalIfRemoteUnavailable".
Variables:
• •
<option1> is one of the options: local , ldap or radius.
Option
local
ldap
radius
• •
<option2> is one of the options: true or false.
Option Description
true Remote authentication is the first priority. The device will switch to local
authentication when the remote authentication is not available.
false Always stick to remote authentication regardless of the availability of
remote authentication.
LDAP Settings
All LDAP-related commands begin with authentication ldap.
If you enable LDAP authentication, you must add at least one LDAP server. Later you can modify or
delete any existing LDAP server as needed.
Adding an LDAP Server
Adding an LDAP server requires the entry of quite a lot of parameters, such as the server's IP address,
TCP port number, Base DN and so on.
You can repeat the following CLI command to add more than one LDAP server.
488
Description
Enable Local authentication only.
Enable LDAP authentication.
Enable Radius authentication.