LEGRAND Server Technology PRO4X User Manual page 430

Method
EAP
Setting Ethernet EAP Parameters
When the selected Ethernet interface's authentication method is set to EAP, you must configure EAP
authentication parameters, including outer authentication, inner authentication, EAP identity, client
certificate, client private key, password, CA certificate, and RADIUS authentication server. For more
information, see Ethernet Interface Settings.
▶
Determine the outer authentication protocol:
config:# network ethernet <ETH> eapOuterAuthentication <outer_auth>
▶
Determine the inner authentication protocol for authentication set to "EAP + PEAP":
config:# network ethernet <ETH> eapInnerAuthentication <inner_auth>
▶
Set the EAP identity:
config:# network ethernet <ETH> eapIdentity <identity>
▶
Set the EAP password:
config:#
After performing the above command, the PRO4X prompts you to enter the password. Then type the
password and press Enter.
▶
Provide a client certificate for authentication set to "EAP + TLS" or "EAP + PEAP + TLS":
config:#
After performing any certificate or private key commands, including commands for the client certificate,
client private key, and CA certificate, the system prompts you to enter the contents of the wanted
certificate or key. For an example with detailed procedure, see
432).
430
Description
The authentication method is set to EAP.
network ethernet <ETH> eapPassword
network ethernet <ETH> eapClientCertificate
EAP CA Certificate Example (on page