Table of Contents
Advertisement
IPv4-Only or IPv6-Only Configuration
To show IPv4-only or IPv6-only configuration, use any of the following commands.
▶
To show IPv4 settings shared by all network interfaces, such as DNS and routes:
#
show network ipv4 common
▶
To show IPv6 settings shared by all network interfaces, such as DNS and routes:
#
show network ipv6 common
▶
To show the IPv4 configuration of a specific network interface:
#
show network ipv4 interface <ETH>
▶
To show the IPv6 configuration of a specific network interface:
#
show network ipv6 interface <ETH>
Variables:
•
•
<ETH> is one of the network interfaces: ETH1/ETH2, WIRELESS, or BRIDGE. Note that you must
choose/configure the bridge interface if your PRO4X is set to the bridging mode.
Note: In the bridging mode, only the IP parameters of the BRIDGE interface function. The IP
parameters of ETH1/ETH2 and WIRELESS interfaces do NOT function.
Interface Description
eth1
Show the IPv4 or IPv6 configuration of the ETH1 interface.
eth2
Show the IPv4 or IPv6 configuration of the ETH2 interface.
wireless
Show the IPv4 or IPv6 configuration of the WIRELESS interface.
bridge
Show the IPv4 or IPv6 configuration of the BRIDGE interface.
387
Advertisement
Table of Contents
Need help?
Do you have a question about the Server Technology PRO4X and is the answer not in the manual?