Clearing Information; Clearing Event Log; Clearing Diagnostic Log For Network Connections; Configuring The Device And Network - LEGRAND Server Technology PRO4X User Manual

Clearing Information

You can use the clear commands to remove unnecessary data.
After typing a "clear" command, press Enter to execute it.
Note: Depending on your login name, the # prompt may be replaced by the > prompt.

Clearing Event Log

This command removes all data from the event log.
# clear eventlog
-- OR --
clear eventlog /y
#
If you entered the command without "/y," a message appears, prompting you to confirm the
operation. Type y to clear the event log or n to abort the operation.
If you type y, a message "Event log was cleared successfully" is displayed after all data in the event log is
deleted.

Clearing Diagnostic Log for Network Connections

This command removes all data from the diagnostic log for both the EAP authentication and WLAN
connection.
# clear networkDiagLog
-- OR --
# clear networkDiagLog /y
If you entered the command without "/y," a message appears, prompting you to confirm the
operation. Type y to clear the log or n to abort the operation.

Configuring the Device and Network

To configure the device or network settings through the CLI, it is highly recommended to log in as the
administrator so that you have full permissions. If you enter configuration mode from user mode, you
may have limited permissions to make configuration changes.
To configure any settings, enter the configuration mode. Configuration commands are case sensitive.
412