Variables:
•
•
<number> is an integer between 1 and 600. The default is 60 samples per log entry.
Network Configuration Commands
A network configuration command begins with network. A number of network settings can be changed
through the CLI, such as the IP address, transmission speed, duplex mode, and so on.
Configuring IPv4 Parameters
An IPv4 configuration command begins with network ipv4.
Setting the IPv4 Configuration Mode
This command determines the IP configuration mode.
config:#
network ipv4 interface <ETH> configMethod <mode>
Variables:
•
•
<ETH> is one of the network interfaces: ETH1/ETH2, WIRELESS, or BRIDGE. Note that you must
choose/configure the bridge interface if your PRO4X is set to the bridging mode.
Note: In the bridging mode, only the IP parameters of the BRIDGE interface function. The IP
parameters of ETH1/ETH2 and WIRELESS interfaces do NOT function.
Interface Description
eth1
Determine the IPv4 configuration mode of the ETH1 interface (wired
networking).
eth2
Determine the IPv4 configuration mode of the ETH2 interface (wired
networking).
wireless
Determine the IPv4 configuration mode of the WIRELESS interface
(that is, wireless networking).
bridge
Determine the IPv4 configuration mode of the BRIDGE interface (that
is, bridging mode).
•
•
<mode> is one of the modes: dhcp or static.
Mode
Description
dhcp
The IPv4 configuration mode is set to DHCP.
418
Need help?
Do you have a question about the Server Technology PRO4X and is the answer not in the manual?