LEGRAND Server Technology PRO4X User Manual page 433

Hide thumbs Also See for Server Technology PRO4X:
Table of Contents

Advertisement

In addition, the procedure of uploading the client certificate and client private key in CLI is similar to the
following example, except for the CLI command.
To provide a CA certificate:
1) Make sure you have entered the configuration mode.
2) Type the following command for ETH1 and press Enter.
config:#
network ethernet eth1 eapCACertificate
3) The system prompts you to enter the contents of the CA certificate.
4) Open a CA certificate using a text editor. You should see certificate contents similar to the following.
5) Select and copy the contents as illustrated below, including the starting line containing "BEGIN
CERTIFICATE" and the ending line containing "END CERTIFICATE."
6) Paste the contents in the terminal.
7) Press Enter.
8) Verify whether the system shows the following command prompt, indicating the provided CA
certificate is valid.
config:#
Removing the Uploaded Certificate or Private Key
The procedures of removing an existing client certificate, client private key or CA certificate in CLI are
similar.
This section illustrates such a procedure for the Ethernet interface "ETH1."
To remove a certificate or private key for ETH1:
1) Make sure you have entered the configuration mode.
2) Type the appropriate command, depending on which file you want to remove, and press Enter.
• Client certificate:
433

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Server Technology PRO4X and is the answer not in the manual?

Table of Contents