LEGRAND Server Technology PRO4X User Manual page 267

a. Assign a name to this action. a.
b. Select the desired action and configure it as needed. b.
c. Click Create. c.
3) Click New Rule to create a new rule.
a. a. Assign a name to this rule.
b. Make sure the Enabled checkbox is selected, to make the new rule active. b.
c. In the Event field, select the event to react to. c.
d. In the 'Available actions' field, select the desired action(s) to respond to the selected event. d.
e. Click Create. e.
▶
To create a scheduled action:
1) Click New Scheduled Action to schedule the desired action.
a. Assign a name to this scheduled action. a.
b. b. Make sure the Enabled checkbox is selected to make the scheduled action active.
c. c. Set the interval time, which ranges from every minute to yearly.
d. In the 'Available actions' field, select the desired action(s). d.
e. e. Click Create.
Built-in Rules and Rule Configuration
There are several built-in event rules, which cannot be deleted. If the built-in event rules do not satisfy
your needs, create new rules.
▶
Built-in rules:
• •
System Event Log Rule:
This causes ANY event occurred to the PRO4X to be recorded in the internal log. It is
enabled by default.
Note: Default log messages are generated for each event.
• •
System SNMP Notification Rule:
This causes SNMP traps or informs to be sent to specified IP addresses or hosts when ANY
event occurs to the PRO4X. It is disabled by default.
• • System Tamper Detection Alarmed:
This causes alarm notifications if a connected tamper sensor is detected to be in an
alarmed state. It is enabled by default.
• •
System Tamper Detection Unavailable:
This causes alarm notifications if a previously available tamper sensor is not detected. It is
enabled by default.
267