Option Description
full
Full duplex:
Data is transmitted in both directions simultaneously.
Setting the LAN MTU
This command sets the MTU for the ethernet interface.
config:#
network ethernet <ETH> mtu <mtu>
Variables:
•
•
<ETH> is one of the options -- eth1 or eth2.
•
•
<mtu> is the Maximum Transfer Unit. Enter a value from 1280-1500.
Setting the Ethernet Authentication Method
PRO4X supports 802.1X (EAP) Network Authentication. Enable the ethernet interface, and then set the
authentication method.
config:# network ethernet <interface> [enabled
<enabled>]
The following command sets the authentication method for the selected Ethernet interface to either
none or Extensible Authentication Protocol (EAP).
config:# network ethernet <ETH> authMethod <method>
Variables:
•
•
<ETH> is one of the options -- eth1 or eth2.
Option
eth1
eth2
•
•
<method> is one of the authentication methods: NONE or EAP.
Method
Description
NONE
The authentication method is set to NONE.
Description
ETH1 port
ETH2 port
429
Need help?
Do you have a question about the Server Technology PRO4X and is the answer not in the manual?