LEGRAND Server Technology PRO4X User Manual page 218

Hide thumbs Also See for Server Technology PRO4X:
Table of Contents

Advertisement

Field/setting
Allow connection
if system clock is
incorrect
Wireless Network Settings
Wireless network is not supported for Bridging mode or for Expansion units in port forwarding mode.
Wireless interface is disabled by default. Enable it to use wireless networking.
On the Network page, click the WIRELESS section to configure wireless and IPv4/IPv6 settings.
Interface Settings:
Field/setting
Enable interface
Hardware state
SSID
Force AP BSSID
BSSID
MTU
Enable High
Throughput
(802.11n)
218
Description
If powered off for a long time, the system time may be incorrect.
When this checkbox is deselected, and if the system time is
incorrect, the installed TLS certificate is considered not valid yet
and will cause the network connection to fail.
When this checkbox is selected, it will make the network
connection successful when the system time is earlier than
the firmware build before synchronizing with any NTP
server.
Description
Enable or disable the wireless interface.
When disabled, the wireless networking fails.
Check this field to ensure that a wireless USB LAN adapter is
detected. If not, verify that the USB LAN adapter is firmly
connected or that it is supported.
Type the name of the wireless access point (AP).
If the BSSID is available, select this checkbox.
Type the MAC address of an access point.
Set the Maximum Transmission Unit from 1280 to 1500.
Enable or disable 802.11n protocol.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Server Technology PRO4X and is the answer not in the manual?

Table of Contents