LEGRAND Server Technology PRO4X User Manual page 434

config:#
• Client private key: •
config:#
• • CA certificate:
config:#
3) The system prompts you to enter the contents of the chosen certificate or private key.
4) Press Enter without typing any data.
5) Verify whether the system shows the following command prompt, indicating the existing certificate
or private key has been removed.
config:#
Setting Wireless Parameters
You must configure wireless parameters, including Service Set Identifier (SSID), authentication method,
Pre-Shared Key (PSK), and Basic Service Set Identifier (BSSID) after the wireless networking mode is
enabled.
A wireless configuration command begins with network wireless.
Note: If wireless networking mode is not enabled, the SSID, PSK and BSSID values are not applied until
the wireless networking mode is enabled. In addition, a message appears, indicating that the active
network interface is not wireless.
Setting the SSID
This command specifies the SSID string.
config:#
Variables:
• •
<ssid> is the name of the wireless access point, which consists of:
- Up to 32 ASCII characters
- No spaces
- ASCII codes 0x20 ~ 0x7E
Enabling or Disabling 802.11n High Throughput
This command enables or disables the 802.11n high throughput protocol.
config:# network wireless enableHT <option>
434
network ethernet eth1 eapClientCertificate
network ethernet eth1 eapClientPrivateKey
network ethernet eth1 eapCACertificate
network wireless SSID <ssid>