Show Ip Vlan; Routing Information Protocol (Rip) Commands; Enable (Rip) - NETGEAR ProSafe FSM7328S User Manual

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Mode

show ip vlan

This command displays the VLAN routing information for all VLANs with routing enabled in the
system.
Format
Mode
MAC Address used by Routing VLANs Is the MAC Address associated with the
internal bridge-router interface (IBRI). The same MAC Address is used by all VLAN routing
interfaces. It will be displayed above the per-VLAN information.
VLAN ID
Logical Interface
IP Address
Subnet Mask

Routing Information Protocol (RIP) Commands

This chapter provides a detailed explanation of the RIP commands. The commands are divided by
functionality into the following different groups:
• Show commands are used to display switch settings, statistics and other information.
• Configuration Commands are used to configure features and options of the switch. For every
configuration command there is a show command that will display the configuration setting.
• Copy commands are used to transfer configuration and informational files to and from the
switch.

enable (RIP)

This command resets the default administrative mode of RIP in the router (active).
Default
Format
Mode
10-22
VLAN Database
show ip vlan
Privileged EXEC and User EXEC
Is the identifier of the VLAN.
Indicates the logical slot/port associated with the VLAN routing
interface.
Displays the IP Address associated with this VLAN.
Indicates the subnet mask that is associated with this VLAN.
enabled
enable
Router RIP Config
202-10088-01, March 2005
Routing Commands