Match Any; Match Class-Map - NETGEAR ProSafe FSM7328S User Manual

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software

match any

This command adds to the specified class definition a match condition whereby all packets are
considered to belong to the class. The optional [
condition for the class (i.e., none of the packets are considered to belong to the class).
Default
Format
Mode

match class-map

This command adds to the specified class definition the set of match conditions defined for another
class. The <
refclassname>
being referenced by the specified class definition.
Note: there is no [
not]
Default
Format
Mode
Restrictions
11-12
none
match [not] any
Class-Map Config
is the name of an existing DiffServ class whose match conditions are
option for this match command.
none
match class-map <refclassname>
Class-Map Config
The class types of both <
be identical (i.e., any vs. any, or all vs. all). A class type of acl is
not supported by this command.
Cannot specify
self-referencing of class name not allowed).
At most one other class may be referenced by a class.
Any attempt to delete the <
enced by any <
The combined match criteria of <
must be an allowed combination based on the class type.
name>
Any subsequent changes to the <
teria must maintain this validity, or the change attempt shall fail.
The total number of class rules formed by the complete reference
class chain (includes both predecessor and successor classes)
must not exceed a platform-specific maximum.
In some cases, each removal of a refclass rule reduces the maxi-
mum number of available rules in the class definition by one.
202-10088-01, March 2005
parameter has the effect of negating this match
not]
classname>
the same as <
<refclassname>
refclassname>
> shall fail.
classname
classname>
refclassname>
Quality of Service (QoS) Commands
and <
refclassname>
classname>
class while still refer-
and <
refclass-
class match cri-
must
(i.e.,