Show Telnetcon - NETGEAR ProSafe FSM7328S User Manual

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Locally Administered MAC Address If desired, a locally administered MAC address
MAC Address Type
Network Configuration Protocol Current Indicates which network protocol is being
Java Mode
Management VLAN ID

show telnetcon

This command displays telnet settings.
Format
Mode
Remote Connection Login Timeout (minutes) This object indicates the number of
Maximum Number of Remote Connection Sessions This object indicates the num-
Switching Commands
can be configured for in-band connectivity. To take effect, 'MAC
Address Type' must be set to 'Locally Administered'. Enter the
address as twelve hexadecimal digits (6 bytes) with a colon
between each byte. Bit 1 of byte 0 must be set to a 1 and bit 0 to a
0, i.e. byte 0 should have the following mask 'xxxx xx10'. The
MAC address used by this bridge when it must be referred to in a
unique fashion. It is recommended that this be the numerically
smallest MAC address of all ports that belong to this bridge.
However it is only required to be unique. When concatenated
with dot1dStpPriority a unique BridgeIdentifier is formed which
is used in the Spanning Tree Protocol.
Specifies which MAC address should be used for in-band con-
nectivity. The choices are the burned in or the Locally Adminis-
tered address. The factory default is to use the burned in MAC
address.
used. The options are bootp | dhcp | none.
Specifies if the switch should allow access to the Java applet in
the header frame. Enabled means the applet can be viewed. The
factory default is disabled.
Specifies the management VLAN ID.
show telnetcon
Privileged EXEC and User EXEC
minutes a remote connection session is allowed to remain inac-
tive before being logged off. A zero means there will be no time-
out. May be specified as a number from 0 to 160. The factory
default is 5.
ber of simultaneous remote connection sessions allowed. The fac-
tory default is 5.
202-10088-01, March 2005
8-25