Show Arp - NETGEAR ProSafe FSM7328S User Manual

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Format
Mode

show arp

This command displays the Address Resolution Protocol (ARP) cache. The displayed results are
not the total ARP entries. To view the total ARP entries, the operator should view the
results in conjunction with the
Format
Mode
Age Time (seconds)
Response Time (seconds) Is the time it takes for an ARP request timeout. This value
Retries
Cache Size
Dynamic Renew Mode Displays whether the ARP component automatically attempts to
Total Entry Count Current / Peak Field listing the total entries in the ARP table and the
Static Entry Count Current / Max Field listing the static entry count in the ARP table and
The following are displayed for each ARP entry.
IP Address
MAC Address
Interface
Type
Age
Routing Commands
clear arp-cache [gateway]
Privileged Exec
results.
show arp switch
show arp
Privileged EXEC
Is the time it takes for an ARP entry to age out. This value was
configured into the unit. Age time is measured in seconds.
was configured into the unit. Response time is measured in sec-
onds.
Is the maximum number of times an ARP request is retried. This
value was configured into the unit.
Is the maximum number of entries in the ARP table. This value
was configured into the unit.
renew dynamic ARP entries when they age out.
peak entry count in the ARP table.
maximum static entry count in the ARP table.
Is the IP address of a device on a subnet attached to an existing
routing interface.
Is the hardware MAC address of that device.
Is the routing slot/port associated with the device ARP entry.
Is the type that was configured into the unit. The possible values
are Local, Gateway, Dynamic and Static.
This field displays the current age of the ARP entry since last
refresh (in hh:mm:ss format
202-10088-01, March 2005
show arp
10-5