Snmp-Server Community; No Snmp-Server Community - NETGEAR ProSafe FSM7328S User Manual

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Multiple Users Flag
Spanning Tree Flag
Broadcast Storm Flag

snmp-server community

This command adds (and names) a new SNMP community. A community name is a name
associated with the switch and with a set of SNMP managers that manage it with a specified
privileged level. The length of name can be up to 16 case-sensitive characters.
Note: Community names in the SNMP community table must be unique. When making multiple
entries using the same community name, the first entry is kept and processed and all duplicate
entries are ignored.
Default
Format
Mode

no snmp-server community

This command removes this community name from the table. The name is the community name to
be deleted.
Format
Mode
Switching Commands
May be enabled or disabled. The factory default is enabled. Indi-
cates whether a trap will be sent when the same user ID is logged
into the switch more than once at the same time (either via telnet
or serial port).
May be enabled or disabled. The factory default is enabled. Indi-
cates whether spanning tree traps will be sent.
May be enabled or disabled. The factory default is enabled. Indi-
cates whether broadcast storm traps will be sent.
Two default community names: Public and Private. You can
replace these default community names with unique identifiers
for each community. The default values for the remaining four
community names are blank.
snmp-server community <name>
Global Config
no snmp-server community <name>
Global Config
202-10088-01, March 2005
8-29