Mode-Based Cli - NETGEAR ProSafe FSM7328S User Manual
Layer 3 managed switch software
Hide thumbs
Also See for ProSafe FSM7328S:
- Administration manual (124 pages) ,
- Hardware installation manual (40 pages) ,
- Operating instructions manual (24 pages)
Table of Contents
Advertisement
User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
The CLI groups all the commands in appropriate modes according to the nature of the command.
A sample of the CLI command modes are described below. Each of the command modes support
specific 7300S Series L3 Switch commands.
•
User Exec Mode
•
Privileged Exec Mode
•
Global Config Mode
•
Vlan Mode
•
Interface Config Mode
•
Line Config Mode
•
Policy Map Mode
•
Policy Class Mode
•
Class Map Mode
•
Router Config RIP Mode
•
DHCP Pool Configuration Mode
The Command Mode table captures the command modes, the prompts visible in that mode and the
exit method from that mode.
Table 7-1.
Command Mode
Command Mode
User Exec Mode
Privileged Exec Mode
Mode-based CLI
Access Method
This is the first level of
access. Perform basic
tasks and list system
information.
From the User Exec
enable
Mode, enter the
command.
202-10088-01, March 2005
Mode-based CLI
Prompt
Switch>
Switch#
Chapter 7
Exit or Access Next
Mode
Enter Logout command
To exit this mode, enter
exit or press Ctrl-Z.
7-1
Advertisement
Table of Contents
