NETGEAR ProSafe FSM7328S User Manual page 298

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
If the Policy Name is specified the following fields are displayed:
Policy Name
Type
The following information is repeated for each class associated with this policy (only those policy attributes
actually configured are displayed):
Class Name
Mark CoS
Mark IP DSCP
Mark IP Precedence
Policing Style
Committed Rate (Kbps) This field displays the committed rate, used in simple policing,
Committed Burst Size (KB) This field displays the committed burst size, used in simple
Excess Burst Size (KB) This field displays the excess burst size, used in single-rate polic-
Peak Rate (Kbps)
Peak Burst Size (KB)
Conform Action
11-34
ing action. It may also be specified along with a QoS queue
assignment.
The name of this policy.
The policy type, namely whether it is an inbound or outbound
policy definition.
The name of this class.
Denotes the class of service value that is set in the 802.1p header
of outbound packets. This is not displayed if the mark cos was not
specified.
Denotes the mark/re-mark value used as the DSCP for traffic
matching this class. This is not displayed if mark ip description is
not specified using the police-two-rate command, or if policing is
in use for the class under this policy.
Denotes the mark/re-mark value used as the IP Precedence for
traffic matching this class. This is not displayed if precedence is
not specified using police-two-rate command, or if either mark
DSCP or policing is in use for the class under this policy.
This field denotes the style of policing, if any, used (simple, sin-
gle rate, or two rate).
single-rate policing, and two-rate policing.
policing, single-rate policing, and two-rate policing.
ing.
This field displays the peak rate, used in two-rate policing.
This field displays the peak burst size, used in two-rate policing.
The current setting for the action taken on a packet considered to
conform to the policing parameters. This is not displayed if polic-
ing is not in use for the class under this policy.
202-10088-01, March 2005
Quality of Service (QoS) Commands