User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Mode
set prompt
This command changes the name of the prompt. The length of name may be up to 64 alphanumeric
characters.
Format
Mode
serviceport ip
This command sets the IP address, the netmask and the gateway of the router.
Format
Mode
serviceport protocol
This command specifies the servicePort configuration protocol. If you modify this value, the
change takes effect immediately.
Format
Mode
show telnet
This command displays the current outbound telnet settings.
Format
Modes
Outbound Telnet Login Timeout (in minutes) Indicates the number of minutes an outbound telnet
session is allowed to remain inactive before being logged off. A value of 0, which is the default,
results in no timeout.
Maximum Number of Outbound Telnet Sessions Indicates the number of simultaneous outbound
telnet connections allowed.
Switching Commands
Line Config
set prompt <prompt string>
Privileged EXEC
serviceport ip <ipaddr> <netmask> [gateway]
Privileged EXEC
serviceport protocol {none | bootp | dhcp}
Privileged EXEC
show telnet
Privileged EXEC
User EXEC
202-10088-01, March 2005
8-23