Spanning-Tree Max-Age; No Spanning-Tree Max-Age; Spanning-Tree Mst - NETGEAR ProSafe FSM7328S User Manual

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
This command sets the admin Hello Time parameter for the common and internal spanning tree to
the default value.
Format
Mode

spanning-tree max-age

This command sets the Bridge Max Age parameter to a new value for the common and internal
spanning tree. The max-age value is in seconds within a range of 6 to 40, with the value being less
than or equal to "2 times (Bridge Forward Delay - 1)".
Default
Format
Mode

no spanning-tree max-age

This command sets the Bridge Max Age parameter for the common and internal spanning tree to
the default value, i.e. 20.
Format
Mode

spanning-tree mst

This command sets the Path Cost or Port Priority for this port within the multiple spanning tree
instance or in the common and internal spanning tree. If the <mstid> parameter corresponds to an
existing multiple spanning tree instance, then the configurations are done for that multiple
spanning tree instance. If however 0 (defined as the default CIST ID) is passed as the <mstid>,
then the configurations are performed for the common and internal spanning tree instance.
If the 'cost' token is specified, this command sets the path cost for this port within a multiple
spanning tree instance or the common and internal spanning tree instance, depending on the
<mstid> parameter. The pathcost can be specified as a number in the range of 1 to 200000000 or
auto. If "auto" is specified, the pathcost value will be set based on Link Speed.
8-122
no spanning-tree hello-time
Interface Config
20
spanning-tree max-age <6-40>
Global Config
no spanning-tree max-age
Global Config
202-10088-01, March 2005
Switching Commands