No Spanning-Tree Configuration Revision; Spanning-Tree Edgeport; No Spanning-Tree Edgeport; Spanning-Tree Forceversion - NETGEAR ProSafe FSM7328S User Manual
Layer 3 managed switch software
Hide thumbs
Also See for ProSafe FSM7328S:
- Administration manual (124 pages) ,
- Hardware installation manual (40 pages) ,
- Operating instructions manual (24 pages)
Table of Contents
Advertisement
User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
no spanning-tree configuration revision
This command sets the Configuration Identifier Revision Level for use in identifying the
configuration that this switch is currently using to the default value, i.e. 0.
Format
Mode
spanning-tree edgeport
This command specifies that this port is an Edge Port within the common and internal spanning
tree. This will allow this port to transition to Forwarding State without delay.
Format
Mode
no spanning-tree edgeport
This command specifies that this port is not an Edge Port within the common and internal
spanning tree.
Format
Mode
spanning-tree forceversion
This command sets the Force Protocol Version parameter to a new value. The Force Protocol
Version can be one of the following:
•
802.1d - ST BPDUs are transmitted rather than MST BPDUs (IEEE 802.1d functionality
supported)
•
802.1w - RST BPDUs are transmitted rather than MST BPDUs (IEEE 802.1w functionality
supported)
•
802.1s - MST BPDUs are transmitted (IEEE 802.1s functionality supported)
Default
Format
Mode
8-120
no spanning-tree configuration revision
Global Config
spanning-tree edgeport
Interface Config
no spanning-tree edgeport
Interface Config
802.1s
spanning-tree forceversion <802.1d | 802.1w | 802.1s>
Global Config
202-10088-01, March 2005
Switching Commands
Advertisement
Table of Contents
