Set Garp Timer Leave All; No Set Garp Timer Leave All - NETGEAR ProSafe FSM7328S User Manual

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Mode

set garp timer leave all

This command sets the GVRP leave time for all ports. Leave time is the time to wait after
receiving an unregister request for a VLAN or a multicast group before deleting the VLAN entry.
This can be considered a buffer time for another station to assert registration for the same attribute
in order to maintain uninterrupted service.time is 20 to 600 (centiseconds). The value 60
centiseconds is 0.6 seconds.
Note:
This command has an effect only when GVRP is enabled.
Default
Format
Mode

no set garp timer leave all

This command sets the GVRP leave time for all ports to the default 60 centiseconds (0.6 seconds).
Note:
This command has an effect only when GVRP is enabled.
Format
Mode
set garp timer leaveall
This command sets how frequently
indicates that all registrations will be unregistered. Participants would need to rejoin in order to
maintain registration. The value applies per port and per GARP participation. The time may range
from 200 to 6000 (centiseconds). The value 1000 centiseconds is 10 seconds.
Note:
This command has an effect only when GVRP is enabled.
Default
Format
Mode
no set garp timer leaveall
This command sets how frequently
seconds). .
8-98
Interface Config
60
set garp timer leave all <20-600>
Global Config
no set garp timer leave all
Global Config
are generated per port. A
Leave All PDUs
1000
set garp timer leaveall <200-6000>
Interface Config
are generated per port to 1000 centiseconds (10
Leave All PDUs
202-10088-01, March 2005
Leave All PDU
Switching Commands