NETGEAR ProSafe FSM7328S User Manual page 208

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
If 0 (defined as the default CIST ID) is passed as the <mstid>, then this command displays the
settings and parameters for a specific switch port within the common and internal spanning tree.
The <slot/port> is the desired switch port. In this case, the following are displayed.
Port Identifier
Port Priority
Port Forwarding State
Port Role
Port Path Cost
Designated Root
Designated Port Cost
Designated Bridge
Designated Port Identifier
Topology Change Acknowledgement
Hello Time
Edge Port
Edge Port Status
Point To Point MAC Status
CST Regional Root
CST Port Cost
8-138
The port identifier for this port within the CST.
The priority of the port within the CST.
The forwarding state of the port within the CST.
The role of the specified interface within the CST.
The configured path cost for the specified interface.
Identifier of the designated root for this port within the CST.
Path Cost offered to the LAN by the Designated Port.
The bridge containing the designated port
Port on the Designated Bridge that offers the lowest cost to
the LAN
Value of flag in next Configuration Bridge Pro-
tocol Data Unit (BPDU) transmission indicating if a topology
change is in progress for this port.
The hello time in use for this port.
The configured value indicating if this port is an edge port.
The derived value of the edge port status. True if operating as an
edge port; false otherwise.
Derived value indicating if this port is part of a point to
point link
.
The regional root identifier in use for this port.
The configured path cost for this port.
202-10088-01, March 2005
Switching Commands