Police-Single-Rate - NETGEAR ProSafe FSM7328S User Manual

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Restrictions
Policy Type
Incompatibilities

police-single-rate

This command is used to establish the traffic policing style for the specified class. The single-rate
form of the police command uses a single data rate and two burst sizes, resulting in three
outcomes: conform, exceed and violate. The conforming data rate is specified in kilobits-per-
second (Kbps) and is an integer from 1 to 4294967295. The conforming burst size is specified in
kilobytes (KB) as an integer from 1 to 128. The exceeding burst size is specified in kilobytes (KB)
as an integer from 1 to 128. Note that the exceeding burst size must be equal to or greater than the
conforming burst size.
For each outcome, the only possible actions are drop, set-cos-transmit, set-sec-cos-transmit, set-
dscp-transmit, set-prec-transmit, or transmit. In this singlerate form of the police command, the
conform action defaults to send, the exceed action defaults to drop, and the violate action defaults
to drop. These actions can be set with this command once the style has been configured.
For set-dscp-transmit, a <
63, or symbolically through one of the following keywords:
af33, af41, af42, af43, be, cs0, cs1, cs2, cs3, cs4, cs5, cs6, cs7, ef
For set-prec-transmit, an IP Precedence value is required and is specified as an integer from 0-7.
Format
Mode
Restrictions
Policy Type
Incompatibilities
Quality of Service (QoS) Commands
Only one style of police command (simple, singlerate, tworate) is
allowed for a given class instance in a particular policy.
In
Mark IP DSCP, Mark IP Precedence
value is required and is specified as either an integer from 0 to
dscpval>
police-single-rate {<1-4294967295> <1-128> <1-128>
conform-action {drop | set-cos-transmit <0-7> | set-
sec-cos-transmit <0-7> | set-prec-transmit <0-7> |
set-dscp-transmit <0-63> | transmit} exceed-action
{drop | set-cos-transmit <0-7> | set-sec-cos-transmit
<0-7> | set-prec-transmit <0-7> | set-dscp-transmit
<0-63> | transmit} [violate-action {drop | set-cos-
transmit <0-7> | set-sec-cos-transmit <0-7> | set-
prec-transmit <0-7> | set-dscp-transmit <0-63> |
transmit}]}
Policy-classmap Config
Only one style of police command (simple, singlerate, tworate) is
allowed for a given class instance in a particular policy.
In
Mark IP DSCP, Mark IP Precedence
202-10088-01, March 2005
af11, af12, af13, af21, af22, af23, af31, af32,
.
11-25