Storm-Control Flowcontrol; No Storm-Control Flowcontrol; Show Mac-Address-Table Multicast - NETGEAR ProSafe FSM7328S User Manual

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Table 2. Broadcast Storm Recovery Thresholds
Link Speed
10M
100M
1000M
Format
Mode

storm-control flowcontrol

This command enables 802.3x flow control for the switch.
Note: This command only applies to full-duplex mode ports.
Default
Format
Mode

no storm-control flowcontrol

This command disables 802.3x flow control for the switch.
Note: This command only applies to full-duplex mode ports.
Format
Mode

show mac-address-table multicast

This command displays the Multicast Forwarding Database (MFDB) information. If the command
is entered with no parameter, the entire table is displayed. This is the same as entering the optional
all parameter. The user can display the table entry for one MAC Address by specifying the MAC
address as an optional parameter.
Format
Mode
Mac Address
8-44
High
20
5
5
no storm-control broadcast
Global Config
disabled
storm-control flowcontrol
Global Config
no storm-control flowcontrol
Global Config
show mac-address-table multicast <macaddr | all>
Privileged EXEC
A multicast MAC address for which the switch has forwarding and or filtering
information. The format is two-digit hexadecimal numbers that are separated by
colons, for example 01:23:45:67:89:AB. In an IVL system the MAC address
will be displayed as a MAC address and VLAN ID combination of 8 bytes.
202-10088-01, March 2005
Low
10
2
2
Switching Commands