Storm-Control Broadcast; No Storm-Control Broadcast - NETGEAR ProSafe FSM7328S User Manual

User Manual for the NETGEAR 7300S Series Layer 3 Managed Switch Software
Format
Mode
Acceptable values are:
100h
100f
10h
10f

storm-control broadcast

This command enables broadcast storm recovery mode. If the mode is enabled, broadcast storm
recovery with high and low thresholds is implemented.
The threshold implementation follows a percentage pattern. If the broadcast traffic on any Ethernet
port exceeds the high threshold percentage (as represented in
discards the broadcasts traffic until the broadcast traffic returns to the low threshold percentage or
less. The full implementation is depicted in the
Table 1. Broadcast Storm Recovery Thresholds
Link Speed
10M
100M
1000M
Format
Mode

no storm-control broadcast

This command disables broadcast storm recovery mode.
The threshold implementation follows a percentage pattern. If the broadcast traffic on any Ethernet
port exceeds the high threshold percentage (as represented in
discards the broadcasts traffic until the broadcast traffic returns to the low threshold percentage or
less. The full implementation is depicted in the
Switching Commands
speed all {<100 | 10> <half-duplex | full-duplex>}
Global Config
100BASE-T half-duplex
100BASE-T full duplex
10BASE-T half duplex
10BASE-T full duplex
Table 1.
High
20
5
5
storm-control broadcast
Global Config
Table 2.
202-10088-01, March 2005
Table 1) of the link speed, the switch
Low
10
2
2
Table 2) of the link speed, the switch
8-43